<HTML><HEAD></HEAD>
<BODY style="BORDER-TOP-STYLE: none; BORDER-RIGHT-STYLE: none; BORDER-LEFT-STYLE: none; BORDER-BOTTOM-STYLE: none"><BR>Roger,<BR><BR>Possibly I missed this but any particular hairspray brand that has the right amount of solids etc.<BR><BR>David Ilvedson, RPT<BR>Pacifica, California<BR><BR><BR><BR>
<DIV style="PADDING-RIGHT: 5px; PADDING-LEFT: 5px; PADDING-BOTTOM: 5px; BORDER-LEFT: #000000 3px solid; PADDING-TOP: 5px">
<HR>
Original message<BR>From: "Roger Jolly" <ROGER.J@SASKTEL.NET><BR>To: "Pianotech List" <PIANOTECH@PTG.ORG><BR>Received: 4/5/2006 6:45:45 PM<BR>Subject: Re: hairspray hammer hardner question<BR><BR>
<P align=left><FONT size=3>Hi Julie,<BR> The sand paper is only used if you apply too much spray. The nice thing about this method , is that there is a small amount of material and will not soak into the hammer very far. It's dry in a few minutes.<BR>Use a very light grade of sand paper about 400 grit, if needed.<BR>I am assuming the hammers have been pre filed to obtain some extra brightness.<BR><BR>Regards Roger<BR><BR><BR><BR>At 09:59 AM 4/5/2006, you wrote:<BR></P>
<BLOCKQUOTE class=cite cite="" type="cite">Greetings Rodger,<BR> <BR> If I use the hairspray, do I use light sandpaper, BEFORE or AFTER spraying?<BR>Also doesnt sanding the hammer make it softer?<BR> <BR>Thanks in advance,<BR>Julia Gottshall<BR>Reading, PA<BR> <BR>In a message dated 3/31/2006 9:20:27 PM Eastern Standard Time, roger.j@sasktel.net writes:<BR></FONT>
<DL>
<DD>Hi Julia,<BR>
<DD> A nice simple solution. Mask off the surrounding hammers, Spay the crown with a light coat of hair spray, should bring back the sparkle. Easy to reverse, by lightly sanding, very controlled.<BR></DD></DL></BLOCKQUOTE></DIV></BODY></HTML>