<html>
<body>
<font size=3>Hi Julie,<br>
The sand paper is only used if you apply too much spray. The nice
thing about this method , is that there is a small amount of material and
will not soak into the hammer very far. It's dry in a few
minutes.<br>
Use a very light grade of sand paper about 400 grit, if needed.<br>
I am assuming the hammers have been pre filed to obtain some extra
brightness.<br><br>
Regards Roger<br><br>
<br><br>
At 09:59 AM 4/5/2006, you wrote:<br>
<blockquote type=cite class=cite cite="">Greetings Rodger,<br>
<br>
If I use the hairspray, do I use light sandpaper, BEFORE or AFTER
spraying?<br>
Also doesnt sanding the hammer make it softer?<br>
<br>
Thanks in advance,<br>
Julia Gottshall<br>
Reading, PA<br>
<br>
In a message dated 3/31/2006 9:20:27 PM Eastern Standard Time,
roger.j@sasktel.net writes:<br>
</font>
<dl>
<dd>Hi Julia,<br>
<dd>
A nice simple solution. Mask off the surrounding hammers,
Spay the crown with a light coat of hair spray, should bring back the
sparkle. Easy to reverse, by lightly sanding, very controlled.<br>
</dl></blockquote></body>
</html>