<html>
<body>
IMO, any e-mail you receive that says anything about "african"
in it, DELETE IT! Especially if you didn't request it!!!!! <br><br>
Avery<br><br>
At 04:16 PM 4/22/2006, you wrote:<br>
<blockquote type=cite class=cite cite=""><font face="Arial, Helvetica">I
received an interesting e-mail today. Did everyone receive this
e-mail or just me? I've never even heard of this. If not,
then these folks must have found me on an online ad I had promoting
my piano tuning. What do you guys think? I'm not a dealer,
but maybe someone out there is and has heard of this.<br>
</font>
<br>
PAPAVO
PAPAVO
PAPAVO<br>
<br>
WE ARE LOOKING FOR A PARTNER-DEALER TO SELL IN TH USA BALAFONS<br>
<br>
BALAFON IS AFRICAN PIANO ,ORGAN,<br>
<br>
BALAFON IS THE ONLY AFRICAN KEYBOARD,IT EXISTE HERE SINCE SOME <br>
THOUSANDS YEARS<br>
<br>
DELIVRY ON ADRESS INDICATED<br>
<br>
FREE SHIPING<br>
<br>
WHOLESALE : 200 USD FOR ONE<br>
<br>
RETAIL : 400 USD FOR ONE<br><br>
Remarque : message transféré en pièce jointe.<br>
----- Original Message ----- <br>
<dl>
<dd>From:</b> <a href="mailto:greyco@kingston.net">Owen Greyling</a>
<br>
<dd>To:</b> <a href="mailto:pianotech@ptg.org">pianotech@ptg.org</a>
<br>
<dd>Sent:</b> Friday, April 21, 2006 6:49 AM<br>
<dd>Subject:</b> pin block repacement<br><br>
<dd><font face="Arial, Helvetica" size=2>Hello list,<br>
<dd> <br>
<dd>I have a question regarding a procedure for removing a Hardman pin
block. I have replaced blocks before, but this one appears to have been
installed using a slightly different technique. While being doweled and
glued to the inner rim shelf, there is also a mortise or rabbet under the
stretcher that the pin block material is let into. The veneer on the
front of the stretcher at each end, leads me to suspect that the block /
stretcher were originally installed as a unit. Not really wanting to
remove the stretcher, I’m wondering if I could simply cut the block out
in the normal fashion (router and big bit), leaving the part of the old
block that is under the stretcher intact and gluing the new block to
that. This is complicated by the presence of a large cove cut in the
bottom of the block / stretcher for fallboard clearance. I’m hoping
that some one has done this before, and can offer a procedure that has
worked in the past.<br>
<dd> <br>
<dd>Thanks for any help at all,<br>
<dd> <br>
<dd>Owen (Kingston, Ontario, Canada)<br>
<dd> <br>
</font>
</dl></blockquote></body>
</html>