<html>
<body>
<font size=3><br>
Hi Cy,<br>
The answer
is no. You tend to over ease the BR hole to get rid of the
spongy feel, and it leads to key chucking problems. I
have had to correct quite a few BR holes that have been over eased, when
the real problem has been BR height. Sad to say, but I have
been one of the guilty ones. (blush, blush.)<br>
At least I'm honest.<br>
Regards Roger<br><br>
<br>
At 08:22 AM 4/29/2006, you wrote:<br>
</font><blockquote type=cite class=cite cite=""><font size=2>If you use
the standard balance hole easer from the top (the one with V-shaped
sides), will that give equivalent results? It will push back the
top edges of the too-tall hole instead of reaming the step lower, but
will the balance pin know the difference?<br>
</font><font size=3> <br>
</font><font size=2>--Cy--<br>
<b>shuster</b>piano.com<br>
</font><font size=3>
<dl>
<dd>----- Original Message -----
<dd>From: <a href="mailto:jcgrassi@earthlink.net">Jeannie Grassi</a>
<dd>To: <a href="mailto:pianotech@ptg.org">'Pianotech List'</a>
<dd>Sent: Thursday, April 27, 2006 11:58 AM
<dd>Subject: RE: Hammers blocking in Seiler uprights<br><br>
</font>
<dd><font size=3 color="#0000FF">Every new Schimmel I’ve serviced in the
past couple of years has needed this work done. And John shows the
tool!</font><font size=3></font>
<dd><font size=3 color="#0000FF">jeannie</font><font size=3>
<dd> <br>
<dd> <br><br>
</font>
<dd><font face="Times New Roman, Times" size=2 color="#0000FF">Jeannie
Grassi, RPT
<dd>Registered Piano Technician
<dd>Island Piano Service
<dd>Bainbridge Island, WA
<dd>206-842-3721</font>
<dd><font size=3><a href="mailto:jcgrassi@earthlink.net">
mailto:jcgrassi@earthlink.net</a><br>
<dd> </font>
</dl></blockquote></body>
</html>