<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD><TITLE>Stupid newbee!!! Stupid! Stupid!</TITLE> <META http-equiv=Content-Type content="text/html; charset=iso-8859-1"> <STYLE type=text/css>BLOCKQUOTE { PADDING-BOTTOM: 0px; PADDING-TOP: 0px } DL { PADDING-BOTTOM: 0px; PADDING-TOP: 0px } UL { PADDING-BOTTOM: 0px; PADDING-TOP: 0px } OL { PADDING-BOTTOM: 0px; PADDING-TOP: 0px } LI { PADDING-BOTTOM: 0px; PADDING-TOP: 0px } </STYLE> <META content="MSHTML 6.00.2900.2873" name=GENERATOR></HEAD> <BODY bgColor=#ffffff> <DIV><FONT face=Arial size=2>Someone mentioned setting the plug in with epoxy, so it bears pointing out that the tight fit suggested below would be for a glue joint. If you are using epoxy (like West System - I usually use it unthickened), you want to make the hole slightly <EM><U>larger</U></EM> than the plug.</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Terry Farrell</FONT></DIV> <BLOCKQUOTE dir=ltr style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px"> <DIV style="FONT: 10pt arial">----- Original Message ----- </DIV> <DIV style="BACKGROUND: #e4e4e4; FONT: 10pt arial; font-color: black"> </DIV> <DIV>><FONT face=Arial color=#000000 size=-4>Drill out  31/32" hole to insert a Ready Made Plug from Pin Block Material</FONT></DIV> <DIV><BR></DIV> <DIV>I'd make that a 31/64" hole for the 32/64 (1/2") plug,</DIV> <DIV>metric would be so much easier.</DIV><X-SIGSEP><PRE>Regards,<BR><BR>Jon Page</PRE></BLOCKQUOTE></BODY></HTML>