<HTML><FONT FACE=arial,helvetica><HTML><FONT COLOR="#000000" FACE="Geneva" FAMILY="SANSSERIF" SIZE="2"><BR>
In a message dated 6/24/06 8:16:51 PM, afinador@ig.com.br writes:<BR>
<BR>
</FONT><FONT COLOR="#000000" FACE="Geneva" FAMILY="SANSSERIF" SIZE="2"><< I promise a statue in the door of our workshop who to help me to find<BR>
tuning pins 6/0 or 7/0 longer than 2-1/2.>><BR>
<BR>
Fransico;<BR>
<BR>
I don't know where to get pins that long. <BR>
You could use the old pins. (clean them up as Joe suggested)<BR>
Just plug the old block with scrap pinblock material.......drill out the block with a 3/8 inch bit .....cut some 3/8 inch plugs and seat them in the old block with a tiny bit of glue......... then when the old holes are all plugged drill new holes with a bit appropiate to the size of your old pins...then you are set to go.<BR>
Just a thought.<BR>
Jim Bryant (FL)</FONT><FONT COLOR="#000000" FACE="Geneva" FAMILY="SANSSERIF" SIZE="2"><BR>
<BR>
<BR>
</FONT><FONT COLOR="#000000" FACE="Geneva" FAMILY="SANSSERIF" SIZE="2"></FONT></HTML>