<HTML style="FONT-SIZE: x-small; FONT-FAMILY: MS Sans Serif"><HEAD> <META http-equiv=Content-Type content="text/html; charset=windows-1252"> <META content="MSHTML 6.00.2900.2963" name=GENERATOR></HEAD> <BODY style="BORDER-TOP-STYLE: none; BORDER-RIGHT-STYLE: none; BORDER-LEFT-STYLE: none; BORDER-BOTTOM-STYLE: none"> <P>Thanks Joe...that's what I'm going to do...Schaff might want to think about modifying that tool and advertising it to techs...</P> <P>Modifications:   fit the anvil pin into the hole of the bottom plate?   replaced pin with the larger one from Pianotek?   Anything with the handle?</P> <P>I've got to say my drill press is working just fine...<BR><BR>David Ilvedson, RPT<BR>Pacifica, CA 94044<BR><BR><BR></P> <DIV style="PADDING-RIGHT: 5px; PADDING-LEFT: 5px; PADDING-BOTTOM: 5px; BORDER-LEFT: #000000 3px solid; PADDING-TOP: 5px"> <HR> Original message<BR>From: "Joseph Garrett" <JOEGARRETT@EARTHLINK.NET><BR>To: pianotech <PIANOTECH@PTG.ORG><BR>Received: 9/5/2006 11:35:21 AM<BR>Subject: Re: Arbor Press?<BR><BR> <P> <DIV align=left>David asked: "Where the heck do you find a small arbor press for lead in hammers? I'm not having any luck in my area...all ..."</DIV> <DIV> </DIV> <DIV>Da vid,</DIV> <DIV>If you have the "bench" version of the Center Pin Press, (Schaff, page 44, Number 178),I'd slightly modify that. It has a minimal amount of "umph", compared to actual Arbor presses.<G></DIV> <DIV>Regards,</DIV> <DIV> </DIV> <DIV> </DIV> <DIV>Joseph Garrett, R.P.T.</DIV> <DIV>Captain, Tool Police</DIV> <DIV>Squares R I</DIV> <DIV> </DIV> <P></P></DIV></BODY></HTML>