<html>
<body>
<font size=3>At 05:29 PM 11/1/2006, you wrote:<br>
<blockquote type=cite class=cite cite="">In a message dated 11/1/2006
6:21:35 PM Eastern Standard Time, josephspiano@comcast.net writes:<br>
</font>
<dl>
<dd><font face="Arial, Helvetica" size=2>I urge those that use CA on
front rail pins to not</i> use the thinnest CA available. My reasons are
as follows:<br>
</font>
<dd><font size=3> <br>
</font>
<dd><font face="Arial, Helvetica" size=2>1) If the pins are so loose that
they rotate too readily, then the thin glue will surely flow clear
through to the other side, maybe even getting on the punchings and felt
or up into the key bushings. (Assuming you're looking for an expedient
method, rather than total disassembly) <br>
</font><font size=3><br>
</font>
</dl><font size=3 color="#400040">When I suggested thinnest CA, I meant a
drop or two applies around the base of the pin from the top with the
punchings removed.</font></blockquote><br>
Isn't that how most techs would do it? I hope so! :-) <br><br>
<blockquote type=cite class=cite cite=""><font size=3> <br>
</font><font face="Arial, Helvetica" size=2 color="#400040">Randy
Mangus<br>
Mangus Piano Service<br>
140 Atkinson Ave.<br>
Wheeling, WV 26003</font></blockquote></body>
</html>