<html> <body> Hi John,                  You have loose bridge pins right along the speaking length of the bridge.   Drop the tension, pull the strings to the side, (looks as if those pins will just pull out with needle nose pliers.) Swab the holes with epoxy, and reinstall pins.   ( new bridge pins may be an idea) With the tension off the bridge check to make sure that both the apron and root are glued to the board.  Repair as required. Fill crack with epoxy. 5 min epoxy will work OK if you heat it with a hair drier, it will run like water.   Makes for a speedy repair. 24 hr West Systems epoxy is stronger, if you want to make it a 2day job. Regards Roger At 10:05 AM 11/30/2006, you wrote: <blockquote type=cite class=cite cite=""> Dear List,   I'm attaching a photo of the lower end of the tenor bridge on a Wurlitzer spinet.  The first two notes (lowest) sound pretty bad in comparison to the rest of the piano.  Sort of nasal, and short on sustain.  The customer asked me before I began tuning if I thought they were out of tune.  They were in fact in pretty darn good intonation and the unisons were good, but the notes had that nasal sound.   Upon inspection I can see some cracks starting at the bridge itself, but you can also see a crack in the "apron" sort-of piece just above the lowest part of that tenor bridge.  I'm wondering if that crack inhibits transfer of vibration to a more flexible part of the soundboard that would enhance sustain, and if I could repair it and improve the sound by filling that crack with either epoxy or a variety of CA glue - maybe a gel type.   Your opinions and insights would be appreciated.   Thanks in advance, John Dorr Helena, MT </blockquote></body> </html>