<html><head><style type="text/css"></style></head><body><div style="font-family:arial, helvetica, sans-serif;font-size:12pt"><DIV style="FONT-SIZE: 12pt; FONT-FAMILY: arial, helvetica, sans-serif">Jon,</DIV> <DIV style="FONT-SIZE: 12pt; FONT-FAMILY: arial, helvetica, sans-serif"> </DIV> <DIV style="FONT-SIZE: 12pt; FONT-FAMILY: arial, helvetica, sans-serif">Okay, now I get it. I had the orientation wrong, thinking the base mounted onto the drill press table.  Thanks for the pics.</DIV> <DIV style="FONT-SIZE: 12pt; FONT-FAMILY: arial, helvetica, sans-serif"> </DIV> <DIV style="FONT-SIZE: 12pt; FONT-FAMILY: arial, helvetica, sans-serif">Thanks,</DIV> <DIV style="FONT-SIZE: 12pt; FONT-FAMILY: arial, helvetica, sans-serif"> </DIV> <DIV style="FONT-SIZE: 12pt; FONT-FAMILY: arial, helvetica, sans-serif">Dave Davis<BR><BR></DIV> <DIV style="FONT-SIZE: 12pt; FONT-FAMILY: times new roman, new york, times, serif">----- Original Message ----<BR>From: Jon Page <jonpage@comcast.net><BR>To: pianotech@ptg.org<BR>Sent: Saturday, January 20, 2007 5:20:06 PM<BR>Subject: Brooks Jig<BR><BR> <DIV>I use Wally's jig but replace the rear support because it was too flexible.<BR>I mounted it on a larger piece of plywood and put a knob on the rear to<BR>easily change the angle.<BR><BR>The main body rotates for rake and the center strip adjusts the angle<BR>up or down for pitch.<BR>-- <BR><BR>Regards,<BR><BR>Jon Page</DIV></DIV> <DIV style="FONT-SIZE: 12pt; FONT-FAMILY: arial, helvetica, sans-serif"><BR></DIV></div></body></html>