<HTML style="FONT-SIZE: x-small; FONT-FAMILY: MS Sans Serif"><HEAD> <META http-equiv=Content-Type content="text/html; charset=windows-1251"> <META content="MSHTML 6.00.5730.11" name=GENERATOR></HEAD> <BODY> <P> <DIV>"<FONT size=+0>Does anyone know if these tools are still made?"</FONT> <DIV><FONT size=+0></FONT> </DIV> <DIV><FONT size=+0>"I use this one for adjusting rocker capstan screws as below."</FONT></DIV> <DIV><FONT size=+0></FONT> </DIV> <DIV><FONT size=+0>AF,</FONT></DIV> <DIV><FONT size=3>Yes, they are. Made by Stanley. Available at Ace Hardware Stores. There is also Phillips version.</FONT></DIV> <DIV><FONT size=3>HOWEVER,....it is not the tool to use for Rocker Capstans, IMO. There is available from Renner a very good off-screwdriver that is far more efficient and exacting. As it is a duplicate of the original one used in factories, it actually WORKS!<G></FONT></DIV> <DIV><FONT size=3>The problem of the ratchet types, is that you cannot get the tactile feel that is needed to accurately adjust rocker capstans.</FONT></DIV> <DIV><FONT size=3>I do use the ratchet off-set thingee for extracting upright spring rails. They're pretty good for that sort of thing.<G></FONT></DIV> <DIV><FONT size=3>Regards,</FONT></DIV></DIV> <DIV> </DIV> <DIV> </DIV> <DIV>Joe Garrett, R.P.T.</DIV> <DIV>Captain of the Tool Police</DIV> <DIV>Squares R I</DIV> <DIV> </DIV> <P></P></BODY></HTML>