<div>hi list</div>
<div> </div>
<div>i'm driving tuning pins on a samick grand. i have the PB supported with the PB support from Schaff, but the bottom lamination is separating from the PB. i've included pictures. i've got the nuts on the PB support as tight as they'll go, but the separation still happens. i've made my through half the pins; i just wanted to see if anyone thinks if i should stop. by the way, i pulled a small piece of the lamination off, so that's why there's a chunk missing in one of the photos.
</div>
<div> </div>
<div>thanks</div>
<div> </div>
<div>daniel carlton</div>