<html><body> <DIV><FONT face="Arial, Helvetica, sans-serif">Hi Everyone,</FONT></DIV> <DIV><FONT face=Arial>I tuned a piano today that I found difficult to keep the felt from coming out when I strip muted it.  The space between the outside of the strings and the plate was too shallow.  What do you guys do in that situation?  </FONT></DIV> <DIV><FONT face=Arial></FONT> </DIV> <DIV><FONT face=Arial>As for ETDs.  I recall someone designing one for the vision impaired.  Is this ready to check out?  Will it be on display at the convention?  </FONT></DIV> <DIV><FONT face=Arial></FONT> </DIV> <DIV><FONT face=Arial>Does anyone here go from left string to middle to right when tuning rather than strip muting?  I do this in the area close to the trebble where the dampers are too close so as not to mangle them.  </FONT></DIV> <DIV><FONT face=Arial></FONT> </DIV> <DIV><FONT face=Arial>I also had a strange occurance todaya while tuning.  When I made the  d#3 d# octave pure the d#g was beating too slow.  When I corrected this, the octave was way off.  Any ideas?  </FONT></DIV> <DIV><FONT face=Arial>Thanks.</FONT></DIV> <DIV><FONT face=Arial>Marshall</FONT></DIV></body></html>