<html><head><style type="text/css"></style></head><body><div style="font-family:arial, helvetica, sans-serif;font-size:12pt"><DIV style="FONT-SIZE: 12pt; FONT-FAMILY: arial, helvetica, sans-serif">Gee, Ron, do I have to show you all my tricks? Since you can't (or shouldn't) have a steady flow of cutting oil on the drill bit, use your favorite 12 volt Black & Decker cordless drill with the almost dead battery and a dull bit and it will save your wrists! On the other hand, better to have a sore wrist than a broken bit....</DIV> <DIV style="FONT-SIZE: 12pt; FONT-FAMILY: arial, helvetica, sans-serif"> </DIV> <DIV style="FONT-SIZE: 12pt; FONT-FAMILY: arial, helvetica, sans-serif">Dave Davis, RPT<BR><BR></DIV> <DIV style="FONT-SIZE: 12pt; FONT-FAMILY: times new roman, new york, times, serif">----- Original Message ----<BR>From: Ron Nossaman <rnossaman@cox.net><BR>To: Pianotech List <pianotech@ptg.org><BR>Sent: Friday, March 2, 2007 12:24:04 PM<BR>Subject: Re: Pinblock/back separation repair<BR><BR> <DIV>> You mentioned that sometimes screws don't line up with backposts. I <BR>> don't have a problem drilling a hole in the plate so there *is* a bolt <BR>> going through all/most of the backposts. <BR>>  <BR>> Dave Davis, RPT<BR><BR><BR>I have a problem with it. It's hard on the wrist when the <BR>drill breaks through the iron and grabs!<BR>Ron N</DIV></DIV> <DIV style="FONT-SIZE: 12pt; FONT-FAMILY: arial, helvetica, sans-serif"><BR></DIV></div></body></html>