<HTML style="FONT-SIZE: x-small; FONT-FAMILY: MS Sans Serif"><HEAD> <META content="MSHTML 6.00.2900.3086" name=GENERATOR></HEAD> <BODY> <DIV> <DIV>If you have a router table setup, you can use a very small ' flush cut ' router bit.</DIV> <DIV>In the end you only need to clean up the notches with a file.</DIV> <DIV> </DIV> <DIV>I'm sure there are other ways too that I would like to hear about.</DIV> <DIV> </DIV> <DIV>Dave</DIV> <DIV> </DIV> <DIV></DIV></DIV> <DIV> </DIV> <BLOCKQUOTE style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid"> <DIV style="FONT: 10pt Arial">----- Original Message ----- </DIV> <DIV style="BACKGROUND: #e4e4e4; FONT: 10pt arial; font-color: black"><B>From:</B> <A title=richard.ucci@att.net href="mailto:richard.ucci@att.net"></A></DIV> <DIV style="FONT: 10pt arial"><B>To: </B><A title=pianotech@ptg.org href="mailto:pianotech@ptg.org">pianotech@ptg.org</A></DIV> <DIV style="FONT: 10pt arial"><B>Sent:</B> 5/19/2007 5:21:02 AM </DIV> <DIV style="FONT: 10pt arial"><B>Subject:</B> keytops</DIV> <DIV><BR></DIV><FONT size=2> <DIV>List,</DIV> <DIV>Just completed a set for a Lester console. What is the preferred method of removing overhang of keytop on sides? I usually use a file and sometimes a drum sander, but I'm looking for something more precise .</DIV> <DIV>Also, I noticed many fine scratches and imperfections in this set. I was very careful with them and I don't think I was the culprit.Anyone else seen the same? Schaff supplied.</DIV> <DIV>Thanks</DIV> <DIV>Rick Ucci/Ucci Piano</DIV></FONT></BLOCKQUOTE></BODY></HTML>