<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; charset=iso-8859-1"> <META content="MSHTML 6.00.2900.3086" name=GENERATOR> <STYLE></STYLE> </HEAD> <BODY bgColor=#ffffff> <DIV><FONT face=Arial size=2>I have an Agraffe Counterbore Tool that I bought from Pianotek (#2332 pg. D-30). Below is a picture of it.</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><IMG alt="" hspace=0 src="cid:000301c79db5$a0fa5430$0501a8c0@DESKTOP" align=baseline border=0></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>It is approximately 0.7" at the fat end of the taper and about 0.6" at the far end. The little flat end piece on the left is 1/4" thick. The Pianotek catalog instructs to use this tool by hand. I have used it that way for years and have been happy with it.</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>But my current project needs to have all its new agraffes ground down a fair bit. I do not relish grinding all these agraffes by hand. I would love to put this thing in some slow turning machine and grind my agraffes that way. But what machine? I wish I could chuck it into my 1/2" drill press. This thing just reeks of some special purpose to the taper, etc. - what the heck is it supposed to mount in?</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Thanks for any ideas/input.</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Terry Farrell</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Terry Farrell<BR>Farrell Piano</FONT></DIV> <DIV> </DIV> <DIV><FONT face=Arial size=2><A href="http://www.farrellpiano.com">www.farrellpiano.com</A><BR><A href="mailto:terry@farrellpiano.com">terry@farrellpiano.com</A></FONT></DIV></BODY></HTML>