<html><div style='background-color:'>Hi! Dean, Tony and David, thanks for your input! I thought the very same, that since these parts need to be replaced, I can use whats left of them to educate myself further. The aim, of course, is to make them perform better. Born out of necessity, actually, a recording session in the middle of the night, not the best time to call a technician! But that was two years ago, and a lot of "seeing and feeling" since then, as well as self-studying and asking technicians that I've met. Parts that need replacement will not respond ideally to being regulated, I guess. This is where the spring tension comes in. I did actually start working on them, and it was then that this problem arose. They are quite tense now, and it indeed causes some hammers to double-blow on the strings. And when I ease them up so that the hammer rises gently when released from check, the jack starts to not wanting to return under the knuckle properly. I was convinced it was due to the reduced weight of the hammers, but you've made me not so sure of that anymore. Knuckles need lubrication? (and replacement?) Spring needs to be cleaned perhaps? By the way, how would you diagnose that a spring needs to be replaced (unless broken of course)? Yes, a mentor would be very welcome, and excuse any language errors, english is not my native tongue. Very glad to hear about your background, Tony! Regards, Danilo </div> <hr>Smaka på vårens godbitar! <a href="http://g.msn.com/8HMASVSE/2746??PS=47575" target="_top">Fräscha middagstips på MSN</a> </html>