<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; charset=iso-8859-1"> <META content="MSHTML 6.00.2800.1543" name=GENERATOR> <STYLE></STYLE> </HEAD> <BODY bgColor=#ffffff> <DIV><FONT face=Arial size=2>Hi all,</FONT></DIV> <DIV><FONT face=Arial size=2>Yesterday I did a repair on a stripped screw hole on a Stark console.</FONT></DIV> <DIV><FONT face=Arial size=2>The legs were held in place with three screws all of which were loose. </FONT></DIV> <DIV><FONT face=Arial size=2>One leg had oversize screws that were again very loose to not holding at all.</FONT></DIV> <DIV><FONT face=Arial size=2>As usual I used CA in the hole to firm up the wood and all but the loosest was good to go. </FONT></DIV> <DIV><FONT face=Arial size=2>On the loosest ( the largest screw ) I filled the hole with toilet paper pushing it in place with</FONT></DIV> <DIV><FONT face=Arial size=2>my capstan tool tip so that a screw way was created. Then added CA until all was moist with CA.</FONT></DIV> <DIV><FONT face=Arial size=2>Waited 15 seconds and attached the legs.</FONT></DIV> <DIV><FONT face=Arial size=2>All screws were able to be tightened as if the hole was new.</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV>Joe Goss RPT<BR>Mother Goose Tools<BR><A href="mailto:imatunr@srvinet.com">imatunr@srvinet.com</A><BR><A href="http://www.mothergoosetools.com">www.mothergoosetools.com</A></DIV> <BLOCKQUOTE dir=ltr style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px"><FONT face=Arial size=2></FONT> </BLOCKQUOTE></BODY></HTML>