That'd be like ca-ca paper and ca.<br><br><div><span class="gmail_quote">On 7/15/07, <b class="gmail_sendername">Joe And Penny Goss</b> <<a href="mailto:imatunr@srvinet.com">imatunr@srvinet.com</a>> wrote:</span>
<blockquote class="gmail_quote" style="border-left: 1px solid rgb(204, 204, 204); margin: 0pt 0pt 0pt 0.8ex; padding-left: 1ex;">
<div bgcolor="#ffffff">
<div><font face="Arial" size="2">Hi all,</font></div>
<div><font face="Arial" size="2">Yesterday I did a repair on a stripped screw hole
on a Stark console.</font></div>
<div><font face="Arial" size="2">The legs were held in place with three screws all
of which were loose. </font></div>
<div><font face="Arial" size="2">One leg had oversize screws that were again very
loose to not holding at all.</font></div>
<div><font face="Arial" size="2">As usual I used CA in the hole to firm up the wood
and all but the loosest was good to go. </font></div>
<div><font face="Arial" size="2">On the loosest ( the largest screw ) I filled the
hole with toilet paper pushing it in place with</font></div>
<div><font face="Arial" size="2">my capstan tool tip so that a screw way was
created. Then added CA until all was moist with CA.</font></div>
<div><font face="Arial" size="2">Waited 15 seconds and attached the
legs.</font></div>
<div><font face="Arial" size="2">All screws were able to be tightened as if the hole
was new.</font></div>
<div><font face="Arial" size="2"></font> </div>
<div>Joe Goss RPT<br>Mother Goose Tools<br><a href="mailto:imatunr@srvinet.com" target="_blank" onclick="return top.js.OpenExtLink(window,event,this)">imatunr@srvinet.com</a><br><a href="http://www.mothergoosetools.com" target="_blank" onclick="return top.js.OpenExtLink(window,event,this)">
www.mothergoosetools.com</a></div>
<blockquote dir="ltr" style="border-left: 2px solid rgb(0, 0, 0); padding-right: 0px; padding-left: 5px; margin-left: 5px; margin-right: 0px;"><font face="Arial" size="2"></font> </blockquote></div>
</blockquote></div><br>