<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; charset=iso-8859-1"> <META content="MSHTML 6.00.6000.16608" name=GENERATOR> <STYLE></STYLE> </HEAD> <BODY> <DIV><FONT face=Arial>Rob, I have the pinblock height set exactly as it was from the factory. Left - Right, Up - Down. All shims in place. The front of the plate is correctly set as it was. Is the adjustment screw at the tail visible/adjustable from the top or do I need to remove the plate to adjust it? I didn't notice it when I had the plate upside down fitting the pinblock.</FONT></DIV> <DIV><FONT face=Arial></FONT> </DIV> <DIV><FONT face=Arial>Al Guecia</FONT></DIV> <DIV><FONT face=Arial></FONT> </DIV> <DIV><FONT face=Arial></FONT> </DIV> <DIV><FONT face=Arial>----- Original Message ----- </FONT> <DIV><FONT face=Arial>From: "Rob Kiddell" <</FONT><A href="mailto:atonal@telusplanet.net"><FONT face=Arial>atonal@telusplanet.net</FONT></A><FONT face=Arial>></FONT></DIV> <DIV><FONT face=Arial>To: "Pianotech List" <</FONT><A href="mailto:pianotech@ptg.org"><FONT face=Arial>pianotech@ptg.org</FONT></A><FONT face=Arial>></FONT></DIV> <DIV><FONT face=Arial>Sent: Wednesday, February 13, 2008 4:24 PM</FONT></DIV> <DIV><FONT face=Arial>Subject: Re: Baldwin SF-10 grand with acu-just hitch pins</FONT></DIV></DIV> <DIV><FONT face=Arial><BR></FONT></DIV><FONT face=Arial>> It's actually extremely easy. The plate rests on three points: the pinblock bass and treble side <BR>> and a set screw underneath the tail of the plate. Check for shims between the ends of the <BR>> pinblock, that is what is used from factory to set the front height. The screw is adjusted at the <BR>> tail for rear height setting. The perimeter plate bolts lock the plate in place when tightened, <BR>> they do not raise or lower the plate.<BR>> <BR>> Regards, <BR>> <BR>> Rob Kiddell RPT<BR>> Edmonton, Canada<BR>>  <BR>> <BR>> On 13 Feb 2008 at 14:00, AlliedPianoCraft wrote:<BR>> <BR>>> <BR>>> I have just finished the pin block ona Baldwin SF-10 I am rebuilding. Does anyone know how to <BR>>> set the plate height on this piano. I can't get in touch with Baldwin tech support. <BR>>> <BR>>> <BR>>> Al Guecia<BR>>> <BR>> <BR>> <BR>></FONT></BODY></HTML>