<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; charset=iso-8859-1"> <META content="MSHTML 6.00.2900.3354" name=GENERATOR> <STYLE></STYLE> </HEAD> <BODY bgColor=#ffffff> <DIV><FONT face=Arial>I'm wrasslin' with an old friend (action) of mine. A while back I installed new front rail pins in new holes in new wood. It was something of a feat to locate the new holes accurately, and surprisingly, most of them came out pretty darn good. However, there are a few that are off to one side or the other - they make the key close to one neighbor and leave a gap on the other side. And of course, one just needs to bend the front rail pin a bit - which I've done, but then I get too much friction. </FONT></DIV> <DIV><FONT face=Arial></FONT> </DIV> <DIV><FONT face=Arial>It seems I need to move a few pins over just a half-millimeter or so. How best to do this accurately? I know I can just "plug and redrill", but without an industrial sized Bridgeport drill press, and little to zero machining expertise, how could I "plug and redrill" super accurately? Or, I was thinking to just get a small round file and enlarge the hole on one side and shim the other side. Or do they make small diameter router bits - if I had the exact size bit, I could just rout the hole the needed amount and shim.</FONT></DIV> <DIV><FONT face=Arial></FONT> </DIV> <DIV><FONT face=Arial>What to do, what to do....? Anyone?</FONT></DIV> <DIV><FONT face=Arial></FONT> </DIV> <DIV><FONT face=Arial>Terry Farrell<BR>Farrell Piano</FONT></DIV> <DIV> </DIV> <DIV><FONT face=Arial><A href="http://www.farrellpiano.com">www.farrellpiano.com</A><BR><A href="mailto:terry@farrellpiano.com">terry@farrellpiano.com</A></FONT></DIV></BODY></HTML>