<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<html>
  <head>
    <title>Re: Keyframe Bedding</title>
  </head>
  <body>
    <div align="left">I remember LaRoy mentioning this in one of the 39 steps classes.&nbsp;&nbsp; I don't think it was stated as general practice?&nbsp;&nbsp; <br/><br/>David Ilvedson, RPT<br/>Pacifica, CA 94044<br/><br/>
      <div style="padding-right: 5px; padding-left: 5px; padding-bottom: 5px; border-left: #000000 3px solid; padding-top: 5px">
        <hr/>Original message<br/>From: &quot;Avery Todd&quot; 
        <ptuner1@gmail.com>&nbsp;</ptuner1@gmail.com><br/>To: &quot;Pianotech List&quot; 
        <pianotech@ptg.org>&nbsp;</pianotech@ptg.org><br/>Received: 7/7/2008 2:55:05 PM<br/>Subject: Re: Keyframe Bedding<br/><br/>
        <div align="left">Dale, </div>
        <div>&nbsp;</div>
        <div>Isn't this similar to what Yamaha does? </div>
        <div>&nbsp;</div>
        <div>Avery Todd<br/><br/></div>
        <div class="gmail_quote">On Mon, Jul 7, 2008 at 4:35 PM, &lt;<a href="mailto:erwinspiano@aol.com">erwinspiano@aol.com</a>&gt; wrote:<br/>
          <blockquote class="gmail_quote" style="padding-left: 1ex; margin: 0px 0px 0px 0.8ex; border-left: #ccc 1px solid"><br/><br/><br/>-----Original Message-----<br/>From: <a href="mailto:erwinspiano@aol.com" target="_blank">erwinspiano@aol.com</a><br/>To: <a href="mailto:ilvey@sbcglobal.net" target="_blank">ilvey@sbcglobal.net</a><br/>Sent: Mon, 7 Jul 2008 2:33 pm<br/>Subject: Re: Keyframe Bedding<br/><br/>
            <div>The key frames in modern grands all have a somewhat arched/pinched key frame arrangement&nbsp; front to back &amp; end to end. Adjusting the bedding bolts to a neutral position to start with &amp; then turning the bolts tighter against the key bed is where the stressing comes from.&nbsp; You can measure the subsequent rise at the front of the keys as the bolts are being turned as &nbsp;per Jon Pages suggestion.&nbsp; The back of the frame is held down by the dags &amp; the ends by the key blocks<br/>&nbsp; Actually this is also a bit of a buffer or safety factor for climate changes. This way the bolts will hopefully stay in contact with the bed in each season &amp; not be so prone to change with humidity &amp; temp.<br/>&nbsp; Dale<br/></div>
          </blockquote>
        </div>
      </div>
    </div>
  </body>
</html>