<div>I knew someone was going to say that, BUT, this will be my first <STRONG><U><EM>paid</EM></U></STRONG> job of the type, so I will feel 100% more comfortable doing it at my shop, rather than in the customers home.  I will do the work in the home after this time on out.</div> <div> </div> <div>Anyone else have any ideas?</div> <div> </div> <div>Matthew<BR><BR><B><I>David Ilvedson <ilvey@sbcglobal.net></I></B> wrote:</div> <BLOCKQUOTE class=replbq style="PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #1010ff 2px solid"> <DIV align=left> <DIV>I pull the action out and CAREFULLY swing it around as if you were going to use the keybed as a work bench.   Then just put you hand around the stack...using it like a handle with the bottom of the keyframe against your leg as you walk.   Keep in mind, the work you are talking about could be done right at the piano saving 2 car trips/travel time!</DIV> <DIV> </DIV> <DIV>David Ilvedson, RPT<BR>Pacifica, CA 94044<BR></DIV> <DIV style="PADDING-RIGHT: 5px; PADDING-LEFT: 5px; PADDING-BOTTOM: 5px; BORDER-LEFT: #000000 3px solid; PADDING-TOP: 5px"> <HR> Original message<BR>From: "Matthew Todd" <TODDPIANOWORKS@ATT.NET> </TODDPIANOWORKS@ATT.NET><BR>To: pianotech@ptg.org<BR>Received: 7/17/2008 12:40:38 PM<BR>Subject: Transporting a Grand Action<BR><BR> <DIV align=left>Hello all,</DIV> <DIV> </DIV> <DIV>I will be transporting a grand action to my shop for hammer resurfacing and repinning.  What is the normal procedure for carrying the action from the piano in the home, out the door to the car?  Do I just carry it as is, or is there a special and more professional way to handle this.  I'm not anticipating rain, but I guess I should be prepared for that as well.</DIV> <DIV> </DIV> <DIV>Any suggestions would be appreciated.</DIV> <DIV> </DIV> <DIV> </DIV> <DIV>Thanks,</DIV> <DIV>Matthew</DIV></DIV></DIV></BLOCKQUOTE><BR>