<br><font size=2 face="sans-serif">David,</font>
<br>
<br><font size=2 face="sans-serif">Contact Roger Gable in Everett, Washington
at rgable2@verizon. net. He and I did this on an old Steinway K about
5 years ago, but don't remember how the jig was set up.</font>
<br>
<br><font size=2 face="sans-serif">Paul</font>
<br>
<br>
<br>
<br>
<br>
<table width=100%>
<tr valign=top>
<td width=40%><font size=1 face="sans-serif"><b>"David Love"
<davidlovepianos@comcast.net></b> </font>
<br><font size=1 face="sans-serif">Sent by: pianotech-bounces@ptg.org</font>
<p><font size=1 face="sans-serif">08/01/2008 10:03 PM</font>
<table border>
<tr valign=top>
<td bgcolor=white>
<div align=center><font size=1 face="sans-serif">Please respond to<br>
Pianotech List <pianotech@ptg.org></font></div></table>
<br>
<td width=59%>
<table width=100%>
<tr valign=top>
<td>
<div align=right><font size=1 face="sans-serif">To</font></div>
<td><font size=1 face="sans-serif">"'Pianotech List'" <pianotech@ptg.org></font>
<tr valign=top>
<td>
<div align=right><font size=1 face="sans-serif">cc</font></div>
<td>
<tr valign=top>
<td>
<div align=right><font size=1 face="sans-serif">Subject</font></div>
<td><font size=1 face="sans-serif">Decapping bridges with a router</font></table>
<br>
<table>
<tr valign=top>
<td>
<td></table>
<br></table>
<br>
<br>
<br><tt><font size=2>A couple of years ago I saw (or dreamt) a router adaptation
to take the<br>
bridge cap off. It consisted of a couple of elevated skids attached
to the<br>
router base that straddled the bridge so that you could basically run a<br>
router down the length of the bridge and take the bridge top down--very<br>
fast, very smooth. Does anyone use that system and can send me a
picture of<br>
the skids and how they attached them? I have some ideas myself but<br>
shortcuts are always welcome. <br>
<br>
David Love<br>
davidlovepianos@comcast.net <br>
www.davidlovepianos.com<br>
<br>
<br>
<br>
</font></tt>
<br>