<div>I wish I would of ran across those plans before I bought the Genesis Jig from Randy Potter for $300.</div> <div> </div> <div> </div> <div>Matthew Jean and David Weiss <djweiss@ntelos.net> wrote:</div> <BLOCKQUOTE class=replbq style="PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #1010ff 2px solid">Check out the Journal from November 2003. Page 10. You will see plans for an easy to build jig to mill keytops using a router. David Weiss -----Original Message----- From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org] On Behalf Of Matt Wynne Sent: Thursday, August 07, 2008 7:42 PM To: pianotech@ptg.org Subject: keytop planer Greetings fellow piano wizards: I searched the archive for this info before this post and there doesn't seem to be much specific info. I have been using a table saw to remove old keytops for years and I would like to switch to a planer, which seems to be a little more civilized. I purchased a Ryobi planer, but it has a stock feeder which pulls work in, but is not conducive to pulling the work out again. The feeder cannot be disabled. I was hoping that any of you who use a planer for keytop removal would be willing to share what type of planer you use. Since I need to acquire one, it probably won't be useful to post about a machine that's been in use for 20 years and no longer readily available. Thanks in advance, Matt </BLOCKQUOTE>