Such as?<BR><BR><B><I>David Ilvedson <ilvey@sbcglobal.net></I></B> wrote: <BLOCKQUOTE class=replbq style="PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #1010ff 2px solid"> <DIV dir=ltr align=left> <DIV>There are better ways to spend your customers money on a piano.   </DIV> <DIV> </DIV> <DIV>David Ilvedson, RPT<BR>Pacifica, CA 94044<BR></DIV> <DIV style="PADDING-RIGHT: 5px; PADDING-LEFT: 5px; PADDING-BOTTOM: 5px; BORDER-LEFT: #000000 3px solid; PADDING-TOP: 5px"> <HR> Original message<BR>From: "Michael Magness" <IFIXPIANOS@YAHOO.COM> </IFIXPIANOS@YAHOO.COM><BR>To: "Pianotech List" <PIANOTECH@PTG.ORG> </PIANOTECH@PTG.ORG><BR>Received: 8/7/2008 8:47:17 PM<BR>Subject: Re: Tuning Pin and Coil Cleaner<BR><BR> <DIV dir=ltr align=left><BR><BR></DIV> <DIV class=gmail_quote dir=ltr>On Thu, Aug 7, 2008 at 8:52 PM, Matthew Todd <SPAN dir=ltr><<A href="mailto:toddpianoworks@att.net">toddpianoworks@att.net</A>></SPAN> wrote:<BR></DIV> <BLOCKQUOTE class=gmail_quote dir=ltr style="PADDING-LEFT: 1ex; MARGIN: 0px 0px 0px 0.8ex; BORDER-LEFT: #ccc 1px solid"> <DIV>Have any of you used the tuning pin and coil cleaner from Schaff?  I was just wondering if it was any good.  If it produces good results without scratching the pins.</DIV> <DIV> </DIV> <DIV> </DIV> <DIV>Thanks,</DIV> <DIV>Matthew</DIV></BLOCKQUOTE> <DIV dir=ltr><BR>Hi Matthew,</DIV> <DIV dir=ltr> </DIV> <DIV dir=ltr>I had occasion to try using it once about 15 years ago and decided that was enough. The 24 rubber bushings fit into the steel cylinder, one at a time of course, you then dip it into the compound and work it up and down over the pin and coil.</DIV> <DIV dir=ltr>IMHO If you use an electric drill you end up with spots of compound everywhere. If you use a hand drill prepare yourself for an all day job, finding a way to clean up the spots and blobs of compound that inevitably drip and dribble on the plate. When you are finished the pins and coils may be brighter but the plate and pressure bar or agraffes won't be. </DIV> <DIV dir=ltr> </DIV> <DIV dir=ltr>Mike<BR clear=all><BR>-- <BR>I feel sorry for the person who can't get genuinely excited about his work. Not only will he never be satisfied, but he will never achieve anything worthwhile. <BR>Walter Chrysler <BR><BR><BR><BR>Michael Magness<BR>Magness Piano Service<BR>608-786-4404<BR><A href="http://www.ifixpianos.com/">www.IFixPianos.com</A><BR>email <A href="mailto:mike@ifixpianos.com">mike@ifixpianos.com</A><BR></DIV></DIV></DIV></BLOCKQUOTE><BR>