<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <html xmlns:m="http://schemas.microsoft.com/office/2004/12/omml"> <head> <META HTTP-EQUIV="Content-Type" CONTENT="text/html; charset=us-ascii"> <meta name=Generator content="Microsoft Word 10 (filtered)"> <title>[CAUT] hammer thickness trimming jig</title> <style>  </style> </head> <body bgcolor=white lang=EN-US link=blue vlink=purple> <div class=Section1> I’ve done that too but it looks like crap and that bugs me.  Nevertheless sometimes that’s the only option.  Best to do it with a gram scale and a Stanwood jig nearby so you can check the strike weights as you go.    <div> David Love davidlovepianos@comcast.net www.davidlovepianos.com </div> -----Original Message----- From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org] On Behalf Of Fenton Murray Sent: Wednesday, August 27, 2008 10:10 PM To: Pianotech List Subject: Re: [CAUT] hammer thickness trimming jig   <div> I've thinned several sets of hung hammers on a sander. I use the disk and the small belt free hand with the hammer supported by a table. I make a couple of go/no go gauges to keep me honest with the tail and the head. It's very quick and easy if not perfectly accurate beautiful machining, but it gets the job (weight reduction)  done. </div> <div> Fenton </div> <blockquote style='border:none;border-left:solid black 1.5pt;padding:0in 0in 0in 4.0pt; margin-left:3.75pt;margin-top:5.0pt;margin-right:0in;margin-bottom:5.0pt'> <div> ----- Original Message ----- </div> <div style='font-color:black'> From: <a href="mailto:davidlovepianos@comcast.net" title="davidlovepianos@comcast.net">David Love</a> </div> <div> To: <a href="mailto:pianotech@ptg.org" title="pianotech@ptg.org">'Pianotech List'</a> </div> <div> Sent: Monday, August 25, 2008 8:34 PM </div> <div> Subject: RE: [CAUT] hammer thickness trimming jig </div> <div>   </div> Table saws and routers always make me a bit nervous especially when trying to support the object in question with hand held pressure.  It seems like one could construct a jig where the hammer is held strike point down so that the shank doesn’t actually get in the way and you could create some kind of holding mechanism so fingers or finger pressure to hold things in place would not need to be used.  The width of the hammer could thus be thinned and weight removed to the point just before where the shank engages.  A belt sander could then be used to clean up the area around the shank were it necessary.  I’ll have to give it some thought when the shop empties of pianos (which isn’t likely any time soon).  It might be easier just to remove the offending set from the shanks, thin them on the Spurlock jig and rehang them.  The customer is paying, after all.  Why put your fingers at risk to save them a few bucks.    <div> David Love davidlovepianos@comcast.net www.davidlovepianos.com </div>   </blockquote> </div> </body> </html>