<div dir="ltr">Hi all - <br>This seems like a pretty beginner level question, so I&#39;m almost embarrassed to ask. I&#39;m working on a small fleet of 30-40 year old Yamaha consoles. Most of them have center pins that have walked out of the butt flanges. However, I&#39;m finding that since these all have the metal tabs on the hammer butts, if I just press the pin back into the joint and tighten the tab screw, it&#39;s a snug fit. No wiggling back and forth, and at most I&#39;m getting 5 swings. I don&#39;t want to assume anything and shirk off what needs to be done, but at the same time, I have other things to do than repinning if this indicates that it *doesn&#39;t* need repinning. Am I making sense? I have a lot of repinning experience, my earliest training was actually with a school full of P22&#39;s which did not have the metal tabs, but had a bunch of repinning needed. Can someone give me a little quick clarity on this? If the pins have walked out is it an absolute that they should be repinned, or is it just a case of no one ever tightened those metal tab screws? <br>
Thanks!<br>-Holly Quigley<br>
</div>