<div dir="ltr"><div><font size="4">Hey Now,</font></div>
<div><font size="4"></font>&nbsp;</div>
<div><font size="4">I have a question for the group. I have a spinet action in the garage for elbow replacement. I was thinking of doing the alcohol/water treatment to the flanges to size the bushings&nbsp;while I got it, just for the heck of it. Upon closer inspection I find the damper flanges are plastic...hmmmm probably the same plastic that the elbows are made of. What effect (if any) would the alcohol/water have on these plastic&nbsp;flanges. The hammer and whippen are normal wood flanges. This would be my target area, if the solution got onto plastic what might happen?</font></div>

<div><font size="4"></font>&nbsp;</div>
<div><font size="4">Thanks in advance for any advise...</font></div>
<div><font size="4"></font>&nbsp;</div>
<div><font size="4">I know I should have left in a hurry, too late for that.</font></div>
<div><font size="4"></font>&nbsp;</div>
<div><font size="4">Steve Blasyak RPT</font></div>
<div><font size="4">Orange County Chapter</font></div>
<div><font size="4"></font>&nbsp;</div>
<div><font size="4">Pura Vida</font></div></div>