<div dir="ltr"><div>List,</div><div><br></div><div>I am reconditioning (prior to regulation) the action of a 1976 Yamaha G3 grand. The questions I have concern the whippen and balancier action centers vis-a-vis Don Mannino&#39;s post below that I found in searching the archives.</div>
<div><br></div><div>In the section of bass whippens I&#39;ve disassembled so far, I&#39;ve noticed most of the whippen flanges are anywhere from 2-3 grams, measured at the screw hole. The balancier measures about 1-2 grams, measured at the drop screw pad.</div>
<div><br></div><div>Regarding what Don wrote below, and I consider him expert in this, I should repin the loose flanges. However, I wanted to ask the list before I jump into this. Is there any reason <span class="Apple-style-span" style="font-style: italic;">not</span> to repin these centers that I am just unaware of? Does Yamaha perhaps have a different standard for their balancier and whippen flange centers? There is also slight sideward play in the whippen centers, so my initial thinking is they could use repinning.&nbsp;</div>
<div><br></div><div>What say you?</div><blockquote class="webkit-indent-blockquote" style="margin: 0 0 0 40px; border: none; padding: 0px;"><br></blockquote><div>Thanks in advance,</div><div><br></div><div>--&nbsp;<br>JF<br></div>
<div><br></div><div>Written by Don Mannino, 8/11/2007 archived at&nbsp;<a href="https://www.moypiano.com/ptg/pianotech.php/2007-August/209291.html">https://www.moypiano.com/ptg/pianotech.php/2007-August/209291.html</a></div><span class="Apple-style-span" style="font-family: Times; font-size: 16px; "><pre>
Here are my usual guidelines, with notes.  Gram measurement is made with a
spring gauge at the screw hole, except where noted.


hammer flange centers 

Depends on felt quality and firmness. My usual range would be 2 - 6 grams,
depending on humidity and bushing quality. 2g during dry conditions is OK
with good bushings, but will give poor tone with spongy bushings.  If it&#39;s
raining and the bushings are not especially firm feeling, pinning at 6 grams
might be good.  Evenness from note to note is most important in this center.

whippen flange centers 

4 - 6 grams 

balancier center 

4 - 5 grams measured at the drop screw pad (with spring detached, of
course).   This is a very tight feeling bushing when you are testing with
the center pin.
 
Jack should be pinned so that it falls slowly of it&#39;s own weight when the
wippen is held with the jack tender pointing up.  This give a correct amount
of friction to match the weight of the upper part of the jack, which helps
control unwanted jack bounces during fast play.
 
Don Mannino</pre></span><br><br>
</div>