<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML><HEAD>
<META http-equiv=Content-Type content="text/html; charset=iso-8859-1">
<META content="MSHTML 6.00.6000.16705" name=GENERATOR>
<STYLE></STYLE>
</HEAD>
<BODY bgColor=#ffffff>
<DIV><FONT face=Arial size=2></FONT>&nbsp;</DIV>
<BLOCKQUOTE dir=ltr 
style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
  <DIV style="FONT: 10pt arial"><STRONG><FONT face=Arial 
  size=2></FONT></STRONG>&nbsp;</DIV>
  <BLOCKQUOTE dir=ltr 
  style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
    <BLOCKQUOTE dir=ltr 
    style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
      <BLOCKQUOTE dir=ltr 
      style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
        <DIV><FONT face=Arial size=2><STRONG>Yes&nbsp;but the rotation is not 
        very great so don't overdo it. I like a good 5mm of material surounding 
        the pivot pin in the tray so anything less requires relocating the pivot 
        in the pivot blocks. Steinway calls for a 15 degree angle of the 
        underlever to the keyend at rest. Trying to achieve a "magic" half 
        stroke line will almost always bring the tray down too low so that it 
        interferes with the dags.</STRONG></FONT></DIV>
        <DIV><FONT face=Arial size=2></FONT>&nbsp;</DIV>
        <DIV>Not an issue with dags as a Piano Disk will be installed - dags are 
        not needed as the back end of the action was cut off - will probably 
        need to install a modified dag at either end of the action where there 
        is a piece of the action remaining that goes the full depth. It will be 
        more of a stop block or similar.&nbsp;</DIV>
        <DIV>&nbsp;Actually - just finished removing material and you are 
        correct, the rotation is small and it looks like I got it right on the 
        first try.</DIV>
        <DIV>Also, the pivot pins are not an issue either as I moved them to 
        align with the center pin of the lift lever. </DIV>
        <DIV>I think the tray elevation and magic line will work ok.</DIV>
        <DIV>Thanks,</DIV>
        <DIV>Gene</DIV></BLOCKQUOTE></BLOCKQUOTE></BLOCKQUOTE></BLOCKQUOTE></BODY></HTML>