<br><font size=2 face="sans-serif">How about just shimming?</font>
<br>
<br><font size=2 face="sans-serif">Paul</font>
<br>
<br>
<br>
<br>
<table width=100%>
<tr valign=top>
<td width=40%><font size=1 face="sans-serif"><b>richard.ucci@att.net</b>
</font>
<br><font size=1 face="sans-serif">Sent by: pianotech-bounces@ptg.org</font>
<p><font size=1 face="sans-serif">10/23/2008 08:24 AM</font>
<table border>
<tr valign=top>
<td bgcolor=white>
<div align=center><font size=1 face="sans-serif">Please respond to<br>
Pianotech List &lt;pianotech@ptg.org&gt;</font></div></table>
<br>
<td width=59%>
<table width=100%>
<tr valign=top>
<td>
<div align=right><font size=1 face="sans-serif">To</font></div>
<td><font size=1 face="sans-serif">pianotech &lt;pianotech@ptg.org&gt;</font>
<tr valign=top>
<td>
<div align=right><font size=1 face="sans-serif">cc</font></div>
<td>
<tr valign=top>
<td>
<div align=right><font size=1 face="sans-serif">Subject</font></div>
<td><font size=1 face="sans-serif">yamaha rebuild</font></table>
<br>
<table>
<tr valign=top>
<td>
<td></table>
<br></table>
<br>
<br>
<br><font size=3>List, I looked at a Yamaha g-3 ca: early-70's (green understring
felt). Needs restringing and new hammers and backchecks. Block is good,
as well as bridges. Whippens good, as well as back action.</font>
<br><font size=3>&nbsp;</font>
<br><font size=3>My question is about the hairline cracks in the board.
Should I risk restringing without replacing the board? It still has crown
and no buzzing etc. Ribs are good.</font>
<br><font size=3>&nbsp;</font>
<br><font size=3>Cost is a consideration here, and a new board would put
him over his budget.</font>
<br><font size=3>Thanks,</font>
<br><font size=3>Rick Ucci/Ucci Piano</font>
<br>