<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML><HEAD>
<META content="text/html; charset=iso-8859-1" http-equiv=Content-Type>
<META name=GENERATOR content="MSHTML 8.00.6001.19019">
<STYLE></STYLE>
</HEAD>
<BODY bgColor=#ffffff>
<DIV><FONT size=2 face=Tahoma> Les:</FONT></DIV>
<DIV><FONT size=2 face=Tahoma> Go to your local home center
and buy a small can of DAP Gel contact cement. The red can, NOT the green
can. Clean the top of the key and the bottom of the ivory of any old
adhesive. Spread a light coat of gel with your finger or a Q-tip or
small brush. Let both surfaces dry until they are no longer
glossy. 10-15 minutes should do it. Carefully place the ivories
in position and apply momentary pressure. DONE! No waiting for
drying time, no clamping, they're ready to go and get tighter with the passage
of time. </FONT></DIV>
<DIV><FONT size=2 face=Tahoma> If you don't need a pint can,
as an alternative I have also used contact cement that comes in a squeeze
tube. Its more liquidy but works as well. Ace hardware carries their
own brand, I carry a tube in my tuning case for occasions such as
yours. </FONT></DIV>
<DIV><FONT size=2 face=Tahoma> I know I'll get a lot of flack
for this suggestion, but I've done this for 20 years and not had one come loose
yet. </FONT></DIV>
<DIV><FONT size=2 face=Tahoma> Mike Kurta, RPT</FONT></DIV>
<DIV><FONT size=2 face=Tahoma> N. Michigan
chapter</FONT></DIV></BODY></HTML>