Hi Alan,<br><br>Your reel and bobbin set up had me laughing out loud since it reminded me of the old &quot;joke techniques&quot;, the kind that used to exist as drawings back in the old days of paper and snail mail newsletters (Ohio and Pennsylvania were big on that as I recall). <br>
<br>The simplicity of your idea is brilliant. But some questions. Could you tell us more of your technique in its use. I imagine that the slow speed of the cordless is an advantage as to control. Also, something of the size of the bobbin. I assume you used spray glue then carefully wrapped sandpaper on the bobbin. What about the seam? This seems easier said than done. From what we can see, your sandpaper wrap looks tight and solid.<br>
<br>Also, RE the bit inserted into the bobbin: I can see drilling a slightly undersized hole at the drill press, but your insertion of the bit must be perfect or you will end up with an out-of-round spinning bobbin. <br><br>
The Forsyth Reel &amp; Bobbin Hammer Shaper. Has a good ring.<br><br><div class="gmail_quote"><blockquote class="gmail_quote" style="margin: 0pt 0pt 0pt 0.8ex; border-left: 1px solid rgb(204, 204, 204); padding-left: 1ex;">
<div bgcolor="#ffffff" text="#000000"><div> </div>
<div><b><font face="Arial" size="2">Did you remove the hammers and place them 
in groups in a vise to dress the </font></b></div></div></blockquote><blockquote class="gmail_quote" style="margin: 0pt 0pt 0pt 0.8ex; border-left: 1px solid rgb(204, 204, 204); padding-left: 1ex;"><div bgcolor="#ffffff" text="#000000">
<div><b><font face="Arial" size="2">hammers, or do them in 
situ?</font></b></div></div></blockquote><div><br>You asked the above question, so wondering your thoughts on this. Assuming the molding/tails are not tapered, do you usually remove upright hammers for gang filing? And have you fashioned a clever tray / vise to gang clamp them all as one. This, too, seems a little tricky.<br>
<br>Anyway, thanks for posting.<br><br></div></div>Nick G.<br>