<DIV style="font-family:Arial, sans-serif; font-size:10pt;"><DIV>seeing lots of discussion about the "new" pianotech list system. Not clear on what has happened. Thought I would post a question and see what happens.</DIV> <DIV>I have changed strings on overstrung section of an upright....lots of help from here...devised more than a few gadgets to do this job.   Now....havent had to do overstrung section on grand yet...but was thinking and looking at the possible hurdles...will I need more gadgets? ie: curtain rods, coathangers, brakeline, or whatever. </DIV> <DIV> </DIV> <DIV>would appreciate a procedure suggestion or two.</DIV> <DIV> </DIV> <DIV>thanks in advance</DIV> <DIV> </DIV> <DIV>Lance Chauvin      Baton Rouge, La.<BR><BR>--- cy@shusterpiano.com wrote:<BR><BR>From: Cy Shuster <cy@shusterpiano.com><BR>To: pianotech@ptg.org<BR>Subject: Re: [pianotech] Fwd: Your membership on ptg_cauthtrt has been put on hold<BR>Date: Mon, 7 Mar 2011 08:01:51 -0700<BR><BR>OK, now here's my problem: I'm not getting any messages from the new Pianotech! I posted a message to the discussion there about using shellac to seal keytops, and I haven't seen any email about it. My setting is "real time" for this discussion. <BR><BR>Any ideas?<BR><BR>--Cy--<BR><BR>Cy Shuster, RPT<BR>Albuquerque, NM<BR><BR>www.shusterpiano.com<BR>www.facebook.com/shusterpiano<BR><BR>On Mar 7, 2011, at 6:48 AM, Avery Todd wrote:<BR><BR>> Thanks, Cy. I did that this morning. I'm just not sure why messages from caut are bouncing back in the first place. I got a reply that I've been removed from the hold list, so I guess I'll see if any messages from caut get through now.<BR>> <BR>> Avery Todd<BR><BR><BR><BR>`</DIV><BR> <BR><HR>Netscape.  Just the Net You Need.</DIV>