Yes sir.<div><br></div><div>WRM</div><div><br></div><div><br><br><div class="gmail_quote">On Fri, May 13, 2011 at 11:30 AM, Albert Picknell <span dir="ltr">&lt;<a href="mailto:pnrfqsnrk@yahoo.ca">pnrfqsnrk@yahoo.ca</a>&gt;</span> wrote:<br>
<blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex;"><table cellspacing="0" cellpadding="0" border="0"><tbody><tr><td valign="top" style="font:inherit"><div>--- On <b>Thu, 5/12/11, William Monroe <i>&lt;<a href="mailto:bill@a440piano.net" target="_blank">bill@a440piano.net</a>&gt;</i></b> wrote:</div>

<blockquote style="border-left:rgb(16,16,255) 2px solid;padding-left:5px;margin-left:5px">
<div>
<div>I&#39;ll lower the tension only in the bass, then proceed with a cutoff wheel, cutting all the strings off, as close to the agraffe or capo as possible.  The bulk of the wire then comes off the hitches in a wad, and the short lengths are pried from the tuning pin with an awl.</div>

<div><br></div>
<div>William R. Monroe</div></div></blockquote>
<div> </div>
<div>Am I correct in assuming you cut the strings on the speaking-length side of the agraffes/capo?</div>
<div> </div>
<div>Thanks,</div>
<div>Bert</div></td></tr></tbody></table></blockquote></div><br><br>
</div>