<font color='black' size='2' face='arial'>
<div><FONT face="Arial, Helvetica, sans-serif">Rick</FONT></div>


<div>&nbsp;</div>


<div>Unless there is a compelling reason to change what is there, I would suggest you use the same damper blocks as the originals. </div>


<div>&nbsp;</div>


<div>Replacing damper levers can be a challenge, but&nbsp;bending&nbsp;the wires before putting them back on the rail is the easiest way. Hold the old lever next to the new one, and make the bends, both front and back and side to side, and cut the ends off. Obviously you'll have to do some tweaking after the action gets back in the piano. </div>


<div>&nbsp;</div>


<div>Wim <br>
<br>
</div>


<div style="CLEAR: both"></div>
<br>
<br>


<div style="FONT-FAMILY: arial,helvetica; COLOR: black; FONT-SIZE: 10pt">-----Original Message-----<br>
From: Richard Ucci &lt;richarducci@comcast.net&gt;<br>
To: pianotech &lt;pianotech@ptg.org&gt;<br>
Sent: Mon, Jun 13, 2011 1:54 am<br>
Subject: [pianotech] Bass dampers<br>
<br>


<div style="BACKGROUND-COLOR: #fff; MARGIN: 0px; FONT-FAMILY: Tahoma, Verdana, Arial, Sans-Serif; COLOR: #000; FONT-SIZE: 12px" id=AOLMsgPart_0_67a73981-be91-450b-8d51-2b18107c7379><PRE style="FONT-SIZE: 9pt"><TT>List,
What are the advantages of using the dowels versus blocks when  
installing new dampers?
Also, has anyone ever replaced a set of damper levers, and how  
challenging  was the wire bending?

Rick Ucci/ Ucci Piano
<A href="http://www.uccipiano.com/" target=_blank>www.uccipiano.com</A>

</TT></PRE></div>
<!-- end of AOLMsgPart_0_67a73981-be91-450b-8d51-2b18107c7379 --></div>
</font>