<font color='black' size='2' face='arial'>
<div style="FONT-FAMILY: arial,helvetica; COLOR: black; FONT-SIZE: 10pt"><FONT color=black size=2 face=arial>What is the best way to determine the correct size tuning pin to when restringing a piano?</FONT></div>
<FONT color=black size=2 face=arial>

<div style="FONT-FAMILY: arial,helvetica; COLOR: black; FONT-SIZE: 10pt"><br>
The original pin on a Steinway M is 3/0 x 2.5.&nbsp; The over-all&nbsp; "feel" of the <br>
original pin is tight and consistent across the block. The torque reading on the <br>
original pin is consistent at 40 In-Lb while flattening the wire. The torque <br>
reading on the original pin with no string attached is about 100 In- Lb.</div>


<div style="FONT-FAMILY: arial,helvetica; COLOR: black; FONT-SIZE: 10pt"><br>
I tried a 3.5. X 2&amp;3/8. The torque reading ( without a string) on the larger pin <br>
is just about the same as the original pin but not quite 100 In- Lb<br>
<br>
 What is the best way to determine the correct size tuning pin to when restringing a piano?<br>
Should I use 3.5 x 2.5. or 4/0 x 2.5??<br>
<br>
Thanks...&nbsp;&nbsp; Bill Fritz, St Louis<br>
</div>


<div style="FONT-FAMILY: arial,helvetica; COLOR: black; CLEAR: both; FONT-SIZE: 10pt"></div>
</FONT></font>