<font color='black' size='2' face='arial'>
<div>Dave</div>


<div>&nbsp;</div>


<div>In the second picture the pin does look like what is referred to as an oval pin, similar to what is found in older square grands. There is a tip for that (part 3128, p. 34 Schaff Catalogue).&nbsp;</div>


<div>&nbsp;</div>


<div>Wim&nbsp;&nbsp;<br>
<br>
</div>


<div style="CLEAR: both"></div>
<br>
<br>


<div style="FONT-FAMILY: arial,helvetica; COLOR: black; FONT-SIZE: 10pt">-----Original Message-----<br>
From: Dave Smith &lt;dsmithpiano@centurylink.net&gt;<br>
To: pianotech &lt;pianotech@ptg.org&gt;<br>
Sent: Thu, Sep 22, 2011 10:02 am<br>
Subject: [pianotech] Geo Broadbent Tuning Pins<br>
<br>


<div id=AOLMsgPart_2_72938431-c26f-48b0-8a1a-7b2b6610a8df>

<div dir=ltr>

<div style="FONT-FAMILY: 'Calibri'; COLOR: #000000; FONT-SIZE: 12pt">

<div style="FONT-FAMILY: ">

<div>I encountered a Geo Broadbent straight-strung grand piano with tuning pins as shown. Piano is over 100 years old. Although the pin shown is a bit chewed up from some previous tech (not this one) using vise grips, it it pretty close to the other undamaged ones still in the piano. No tuning lever tip I have seen will fit this, as the pin is rectangular in shape, .2”x.26” roughly. The pins are threaded into the block with a pretty coarse thread. </div>


<div>&nbsp;</div>


<div></div>


<div></div>


<div></div>


<div>Does anyone know where to find a hammer tip that would fit this type pin? The piano was moved here from South Africa, where apparently the techs had no trouble tuning it :}</div>


<div>&nbsp;</div>


<div></div>


<div></div>


<div>Also the piano is sitting at about 100c flat to A440, but I was assuming it was designed to be tuned at A415 anyway. Any thoughts on this also? Thanks</div>


<div>&nbsp;</div>


<div></div>


<div></div>


<div>Dave Smith</div>


<div>SW FL</div>
</div>
</div>
</div>
</div>
<!-- end of AOLMsgPart_2_72938431-c26f-48b0-8a1a-7b2b6610a8df --><br>
</div>
</font>