I&#39;ve also found that wiggling/jiggling a screw in the threads helps it find the threads without having to turn the screw backwards. Especially helpful with aluminum rails. Saves time.<div><br></div><div>-- <br><div>John Formsma, RPT<br>
</div><div>Blue Mountain, MS</div></div><div><br></div><div><br><div class="gmail_quote">On Wed, Oct 5, 2011 at 2:56 PM, Laura Olsen <span dir="ltr">&lt;<a href="mailto:laura-olsen@att.net">laura-olsen@att.net</a>&gt;</span> wrote:<br>
<blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex;"><br>
&gt; If everyone would take your last sentence to heart, there would be a lot less stripped screws in this world.  Especially in aluminum rails!<br>
<font color="#888888"><br>
<br>
Laura<br>
</font><div><div></div><div class="h5">&gt;&gt; And, remember to turn the screw backwards when starting to<br>
&gt;&gt; re-insert the screw, in the correct hole, THEN turn it in once it &quot;clicks&quot;<br>
&gt;&gt; into it&#39;s thread groove.<br>
&gt;&gt; Regards,<br>
&gt;&gt; Joe<br>
&gt;&gt;<br>
&gt;&gt;<br>
&gt;&gt; Joe Garrett, R.P.T.<br>
&gt;&gt; Captain of the Tool Police<br>
&gt;&gt; Squares R I<br>
&gt;&gt;<br>
&gt;&gt;<br>
&gt;<br>
<br>
</div></div></blockquote></div><br><br>
</div>