<html>
<head>
<meta http-equiv="content-type" content="text/html; charset=ISO-8859-1">
</head>
<body bgcolor="#FFFFFF" text="#000000">
<font face="Arial">Dagnabbit you're right: I wish I had studied the
thing more thoroughly!<br>
<br>
What I think, is this: The let-off (or set-off) button cannot
drop down, because with the HAMMER flange in place on top of its
own flange, the heel (if you can call it that) surrounding the
birdseye, cannot rotate upwards as it is blocked against the base
of the hammer flange.<br>
<br>
In point of fact, it seems superfluous for the buttons to have
flanges with centres at all. They do not need to rotate/move.<br>
<br>
I suppose it was perhaps simpler to manufacture centre-pinned
flange arrangements than to make an angled fixed piece for each
button. Also, with the hammer flange unscrewed and lifted out of
the way, the set-off (or let-off) button could be flipped upwards
in its flange to allow for screwing the button up or down to
adjust set-off. Cumbersome though!<br>
<br>
I'm sending the two pics again just for ease of reference.<br>
<br>
Best regards,<br>
<br>
David.<br>
<br>
<blockquote type="cite">
<pre wrap="">David,
After looking at the picture a bit more, another question came to light:
What keeps the "let-off" button in position??!! It looks like it would just
drop down on the first stroke. Does it have a cord or some such to keep it
in position?
Best,
Joe
Joe Garrett, R.P.T.
Captain of the Tool Police
Squares R I</pre>
</blockquote>
<br>
</font>
</body>
</html>