<div>Doug,</div><div> </div><div>Thank you so much for the reply.</div><div> </div><div>Wesley Hardman</div><div>Scottsboro, Alabama<br><br></div><div class="gmail_quote">On Thu, Nov 10, 2011 at 11:08 PM, Douglas Gregg <span dir="ltr">&lt;<a href="mailto:classicpianodoc@gmail.com">classicpianodoc@gmail.com</a>&gt;</span> wrote:<br>
<blockquote style="margin: 0px 0px 0px 0.8ex; padding-left: 1ex; border-left-color: rgb(204, 204, 204); border-left-width: 1px; border-left-style: solid;" class="gmail_quote">First the disclaimer, I posted the Ballistol TT&amp;T. This is the best<br>

stuff I have ever used for almost anything that is sticky or squeaks.<br>
It beats any silicone based lube and it really lasts. The spray can is<br>
what I carry on the road. I buy them by the dozen.  It comes with a<br>
thin straw to reach difficult places.  The bulk can comes in pints or<br>
gallons. I recently bought a gallon. That gives you some idea how good<br>
I think it is. I put the bulk Ballistol in an olive oil sprayer that<br>
pumps up by hand with an up and down action of the top. You can get<br>
one  at most cooking accessory stores.  The bulk liquid is a bit more<br>
viscous than the spray can. You can dilute it with your favorite<br>
solvent if you like, but you don&#39;t have to and I don&#39;t.  I use the<br>
olive oil sprayer in the shop for action work.<br>
<br>
With an old action on the bench, I will just make a continuous spray<br>
over all the centers. That takes about a minute and you solve all<br>
kinds of issues.  It is the best thing I have found for verdigris. It<br>
works on all but the most stubborn old S&amp;S model Vs. In the home, I<br>
use it to free up any stuck or slow center or key bushing. One shot<br>
and you are done. It saves so much time. Rarely do problems come back.<br>
<br>
 Don&#39;t worry about getting it on felt or leather. It is safe for both.<br>
For knuckles, I mix some MolyKote (molybdenum dioxide) powder with the<br>
bulk form and use it to softens the leather and the Molykote is more<br>
slippery than graphite. Don&#39;t add solvent here or it will harden the<br>
leather. DAMHIK.  I put this on with a metal handled plumbers brush<br>
sold for solder flux.<br>
<br>
If I run across old hard dampers that don&#39;t respond to an emery board<br>
filing, toothbrushing or needling, and I know the owner won&#39;t have<br>
them replaced, I give them a shot of Ballistol. It softens the felt<br>
and quiets them immediately. One caution, on bass strings, it will<br>
dissolve the corrosion on the copper and will transfer the green<br>
residue to the felt. Probably no problem on an old upright but not so<br>
good on a nice new grand.  Also, if overdone, it can get into the<br>
copper winding and could dampen the tone slightly. So go easy around<br>
bass strings. On the good side, if you have a buzzing string that you<br>
can&#39;t quiet short of replacing it, Give a small shot of Ballistol on<br>
the ends of the winding and it will likely quit buzzing. It takes care<br>
of buzzing in old spinet bass strings, etc. with no cost, and you are<br>
a hero. The effect lasts too.<br>
<br>
Use it on trap work too for squeaks,if for no other reason but to find<br>
the squeak. A shot at each moving part will quickly find the culprit.<br>
In most cases, it will cure it too.<br>
<br>
I also use it on my van for squeaky door hinges, stiff door lock<br>
tumblers or frozen ones,and those little bearing/wheels on sliding van<br>
doors that make the door hard to close. Ballistol does not seem to<br>
collect dirt either, so these bearings stay cleaner longer than with<br>
WD-40 or silicone. I don&#39;t even buy WD-40 anymore. I haven&#39;t bought<br>
any silicone based sprays in ages.<br>
<br>
Concerning odor, it does not have a strong smelling solvent in the<br>
spray can and has no solvent in the bulk can, so you are not going to<br>
gas someones living room by using a lot of spray. It does leave an<br>
odor. Initially, it is a bit like a wet dog smell but quickly changes<br>
to a cedar oil-like smell that is not unpleasant. Owners will start<br>
relating that smell to a smooth working action. LOL.<br>
<br>
Ballistol is a light oil and will leave some oil in wood parts. If it<br>
is a brand new white wood action in a showroom, use with care or be<br>
aware that there will be a slight darkening of wood. No problem in old<br>
pianos. It disappears in darker wood.<br>
<br>
Ballistol is a household product in Germany. It has many other uses<br>
too. An interesting one: it is antibacterial and will cure foot rot in<br>
horses. It might even work on athlete&#39;s foot. Not sure about that. But<br>
it was used to good effect in WWI and WWII on wounds as well as on<br>
guns.<br>
<br>
Once you try Ballistol, you will likely reach for it first and might<br>
quit carrying any other lubes.<br>
<br>
Doug Gregg<br>
Classic Piano Doc<br>
Southold, NY<br>
</blockquote></div><br>