<font color='black' size='2' face='Arial, Helvetica, sans-serif'>
<div>Paul</div>


<div>&nbsp;</div>


<div>The idea behind this set up is to adjust the cap&nbsp;nut up to where it is supposed to be. (Snug against the trap). Then, while holding the cap nut with a pair of&nbsp;channel locks,&nbsp;tighten the other nut with a crescent wrench until the two are tight. If they are tight, they will stay. I've had to adjust some where I could just barely undo them. So it does work. </div>


<div>&nbsp;</div>


<div>Wim<br>
<br>
</div>


<div style="CLEAR: both">

<div>&nbsp;</div>
</div>
<br>
<br>


<div style="FONT-FAMILY: arial,helvetica; COLOR: black; FONT-SIZE: 10pt">-----Original Message-----<br>
From: Paul Milesi &lt;paul@pmpiano.com&gt;<br>
To: PTG Pianotech List &lt;pianotech@ptg.org&gt;; my.ptg Pianotech &lt;ptg_pianotechne@egroups.ptg.org&gt;<br>
Sent: Fri, Jan 20, 2012 8:10 pm<br>
Subject: [pianotech] Pedal Rod Adjustable End Nuts, Lock Nuts &amp; Washers<br>
<br>


<div id=AOLMsgPart_1_2e899c07-d858-4436-a21c-ab8ae57e0c95>

<div>

<div>

<div>

<div>

<div>I occasionally run &nbsp;into adjustable pedal rods where the lock nut doesn't really accomplish it's intended task. &nbsp;That is, even with the lock nut securely tightened against the adjustable nut end, with or without a metal lock washer or leather washer, the whole assembly still turns freely and works its way down the pedal rod, introducing lost motion.</div>


<div><br>
</div>


<div>Can someone explain the principle involved with the lock nut &amp; washer, how they're supposed to hold the adjustable end in place, if everything is threaded the same? &nbsp;How is it that, like a Yamaha I worked on today, they often turn in tandem and very freely, even when tightened together? &nbsp;How is a leather or metal washer supposed to help? &nbsp;Sorry, but I'm just not getting this mechanically. &nbsp;Also wondering if there is a "fix" for the problem?</div>


<div><br>
</div>
<FONT face=Verdana,Helvetica,Arial><SPAN style="FONT-SIZE: 14px">Paul Milesi RPT<br>
Washington DC<br>
(202) 246-3136 Cell/Text<br>
<A href="mailto:paul@pmpiano.com">paul@pmpiano.com</A><br>
<A href="http://www.pmpiano.com/" target=_blank>http://www.pmpiano.com</A></SPAN></FONT></div>
</div>
</div>
</div>
</div>
<!-- end of AOLMsgPart_1_2e899c07-d858-4436-a21c-ab8ae57e0c95 --></div>
</font>