<font color='navy' size='2' face='Comic Sans MS, sans-serif'><font face="Comic Sans MS, sans-serif">Dun</font><font color="navy" face="Comic Sans MS, sans-serif" size="2">no. I arc at a 3 inch pivot from the tail for longer blow pianos. Ie 48 mm and 2 3/4" for shorter blow. Checking Yamahas and Steinway they vary only slightly. It works so...<br>
Understanding the actual geometry may not shed much light on the question.<br>
Dale<br>

<br>



<div style="clear:both"><font color="royalblue" size="1"><b><font face="Georgia, Times New Roman, Times, Serif"><font color="black"><font color="mediumblue" face="Comic Sans MS, sans-serif">Dale Erwin RPT-</font><br>

</font></font></b></font><font color="royalblue" size="1"><font color="blueviolet"><b><font color="black" size="2"><font size="1"></font></font></b></font></font><font color="darkgreen"><span style="font-style: italic;"><b><font size="1"><font color="black"><font color="blueviolet"><font color="black"> <font color="black">Mason &amp; Hamlin</font>/Steinway/<font color="black">U.S pianos</font><br>

</font><font color="mediumblue">Pre-hung Ronsen hammer sets/Abel parts</font></font><br>

</font>Sitka Soundboards &amp; Supplies<br>

<font color="black">WWW.Erwinspiano.com</font><br>

<font color="crimson">209-577-8397</font><br>

<font color="darkgreen"></font></font></b></span></font><tt><tt><font color="darkgreen"><br>

&nbsp;</font><br>

&nbsp; <font size="2"></font></tt></tt><br>

<br>

</div>

<br>

<br>



<div style="font-family:arial,helvetica;font-size:10pt;color:black">-----Original Message-----<br>

From: jim &lt;jim@grandpianosolutions.com&gt;<br>

To: pianotech &lt;pianotech@ptg.org&gt;<br>

Sent: Tue, Feb 28, 2012 7:08 pm<br>

Subject: [pianotech] Grand Backcheck Geometry<br>

<br>









<div id="AOLMsgPart_0_2b65701e-d42f-4fb4-af0d-e1652c27ac6a" style="margin: 0px;font-family: Tahoma, Verdana, Arial, Sans-Serif;font-size: 12px;color: #000;background-color: #fff;">

<pre style="font-size: 9pt;"><tt>Lets try that with a more focused example.

In determining the radius of the hammer tail for a grand is 2-1/2 -3" .  
WNG uses an even tighter radius, 1.5" I think.   Why?   THe pivot for 
the shank is at the flange, not 1/2 or 3/4  out on  the shank.

This is presumably to deal with the radius described by the backcheck as 
it swings into full key dip, to avoid interference.  So my question 
(more focused-ly) What is the geometrical relationship between those two 
arcs?

Jim Ialeggio


-- 
Jim Ialeggio
<a href="mailto:jim@grandpianosolutions.com">jim@grandpianosolutions.com</a>
(978) 425-9026
Shirley, MA

</tt></pre>
</div>

 <!-- end of AOLMsgPart_0_2b65701e-d42f-4fb4-af0d-e1652c27ac6a -->



</div>

</font></font>