<table cellspacing="0" cellpadding="0" border="0"><tr><td valign="top" style="font: inherit;"><div>If it stays pretty "live" I&#39;d go with a Mason BB. ( Perhaps one with the synthetic action, especially if there is also not a top-notch, whole-room humidity control system in place.) Less live, Schimmel or Bechstein.<br /><br /> "Dead", Steinway.<br /><br />(Just my opinion as a piano "Thumper". But one who has had to play for hours on end in a lobby about that size for a major film festival.)<br /><br />Thumpe</div></td></tr></table>            <div id="_origMsg_">
                <div style="font-family:arial, helvetica, sans-serif:font-size:10pt">
                    <br />
                    <div style="font-family:times new roman, new york, times, serif;font-size:12pt">
                        <font size="2" face="Tahoma">
                            <hr size="1">
                            <b>
                                <span style="font-weight:bold;">From:</span>
                            </b>
                            Joseph Garrett &lt;joegarrett@earthlink.net&gt;;                            <br>
                            <b>
                                <span style="font-weight:bold:">To:</span>
                            </b>
                            pianotech &lt;pianotech@ptg.org&gt;;                                                                                                     <br>
                            <b>
                                <span style="font-weight:bold:">Subject:</span>
                            </b>
                            Re: [pianotech] Choosing a piano for a recital space                            <br>
                            <b>
                                <span style="font-weight:bold;">Sent:</span>
                            </b>
                            Wed, May 16, 2012 2:51:12 PM                            <br>
                            </font>
                            <br>
                            <table cellspacing="0" cellpadding="0" border="0">
                                <tbody>
                                    <tr>
                                        <td valign="top" style="font:inherit;">Barbara asked:<BR>"Hi List, <BR> A local symphony is getting a new space that will be used as a recital<BR>space. <BR> I haven't been to the room, but I am told that it is 2500-3000 square feet<BR>with 14 foot ceilings. <BR> Right now the space is too lively acoustically; work is going to be done<BR>to get the reverb down to 1.5 seconds. <BR> Anticipated audience size is 150. I was asked how big a piano should be<BR>purchased for the space. <BR> Seems to me a 7 foot would be fine. <BR> Any opinions out there? <BR> Any suggestions of makes &amp; models they should look into? <BR> Thanks! "<BR>&nbsp; <BR>Barbara,<BR>My choice might be a 7'er. However, with the acoustics, as described, I<BR>would get a 7 footer that is not "Glassy", (you pick the make.&lt;G&gt;).<BR>Acoustics are a funny critter and can be daunting. DAMHIK I'd suggest they<BR>get that reverb a whole helluva lot
 lower than 1.5! If a good AIII were<BR>available, that would, easily cover the area. That would be my first<BR>choice, as it can "Carry" far better than most that is available new. Also,<BR>a M&amp;H would be good. My approach would be to have a more varied approach to<BR>the space use...such as string quartets thangs, etc. Utiliizing the space<BR>often, makes for a better maintained piano, imo. There is a similar square<BR>foot facility that I do occasionally. However it has lower ceiling and<BR>carpeting. Capacity about the same. AIII in place, carries very well and<BR>with a full seating still knocks your doors off when the "artist" decides<BR>to create a mini A-Bomb test.&lt;G&gt;<BR>That's my take on it.<BR>Joe<BR><BR><BR>Joe Garrett, R.P.T.<BR>Captain of the Tool Police<BR>Squares R I<BR><BR></td>
                                    </tr>
                                </tbody>
                            </table>
                    </div>
                </div>
            </div>