<table cellspacing="0" cellpadding="0" border="0"><tr><td valign="top" style="font: inherit;"><div>I always turn the plate over and put a few drops of penetrating oil in the agraffe holes from behind, and let them soak for a day before attempting to turn. ("P.B. Blaster" is probably best for this, as it also eats any corrosion a bit.)</div></td></tr></table>            <div id="_origMsg_">
                <div style="font-family:arial, helvetica, sans-serif:font-size:10pt">
                    <br />
                    <div style="font-family:times new roman, new york, times, serif;font-size:12pt">
                        <font size="2" face="Tahoma">
                            <hr size="1">
                            <b>
                                <span style="font-weight:bold;">From:</span>
                            </b>
                            Susan Kline &lt;skline@peak.org&gt;;                            <br>
                            <b>
                                <span style="font-weight:bold:">To:</span>
                            </b>
                             &lt;pianotech@ptg.org&gt;;                                                                                                     <br>
                            <b>
                                <span style="font-weight:bold:">Subject:</span>
                            </b>
                            Re: [pianotech] broken agraffe                            <br>
                            <b>
                                <span style="font-weight:bold;">Sent:</span>
                            </b>
                            Wed, Aug 22, 2012 3:49:14 AM                            <br>
                            </font>
                            <br>
                            <table cellspacing="0" cellpadding="0" border="0">
                                <tbody>
                                    <tr>
                                        <td valign="top" style="font:inherit;">
<font face="Courier New, Courier, monospace">I&#39;ve had good luck by
putting a drop or two of ballistol on the <br>
seam, and then choosing the highest hump on the stub which is out <br>
near the edge, and tapping it counterclockwise with a small
screwdriver, <br>
held at a 45 degree angle. <br>
<br>
I sometimes have to choose another place, or dig out a little <br>
slot for purchase, but sometimes they just start turning out nice <br>
as anything. <br>
<br>
That said, I&#39;ve only fixed six -- but I only had to drill one of <br>
those. And whatever else you were going to do can be done just <br>
as easily after trying this first.<br>
<br>
Susan<br>
</font><br>
Dean May wrote:
<blockquote
 type="cite">
  <pre>Ha! For this one I thought I&#39;d go the Terry Farrell route and use West
System 2 part. :-)

I&#39;m a little stumped, as the break is pretty jagged and recessed, not very
accessible. Nothing to grab ahold of vise grip wise. 

Yep, several others on this pinaner have been changed which makes for an
interesting string plane. 

Dean
Dean W May                (812) 235-5272 voice and text 
PianoRebuilders.com    (888) DEAN-MAY        
Terre Haute IN 47802
-----Original Message-----
  </pre>
  <br>
</blockquote>
</td>
                                    </tr>
                                </tbody>
                            </table>
                    </div>
                </div>
            </div>