<font color='black' size='2' face='Arial, Helvetica, sans-serif'>
<div>MArshall</div>

<div>&nbsp;</div>

<div>I had a screw like that on a&nbsp; Steinway uprgiht. I wound up tapping the screw with a 5 lb sledge hammer. If the tip gets too chewed up, you might need to drill it out. </div>

<div>&nbsp;</div>

<div>Willem </div>

<div></div>

<div style="color: black; font-family: arial,helvetica; font-size: 10pt;">-----Original Message-----<br>
From: Marshall Gisondi &lt;pianotune05@hotmail.com&gt;<br>
To: pianotech &lt;pianotech@ptg.org&gt;<br>
Sent: Thu, Aug 30, 2012 6:23 am<br>
Subject: [pianotech] tight pressure bar screws<br>
<br>







<div id="AOLMsgPart_1_5c1fd7b3-66b2-4773-80ad-d8838510d6b1">





<div dir="ltr">
<font size="3" face="Arial">Hi Everyone,</font><br>

<font size="3" face="Arial">I had a quick question. What is the best way to free up tight pressure bar screws?&nbsp; I'm dismantling this old piano my brother had, an old cable Nelson player to be exact.&nbsp; The pressure bar screws are tight tight tight won't budge. My screw driver just cuts up the crew head.&nbsp; Unfortunately I don't have electric that far out in the yard well it's more like a drive way in our duplex we rent.&nbsp; I do have a 3/8 drill I believe black and decker. If I couldget a cord long enough out there would that free it up or is there somethign I can appy to it to free it up.&nbsp; It is one frozen screw.&nbsp; I put all mof my 189lbs into it and it won't budge, and I've done physical work most of my life.&nbsp; Thanks everyone</font><br>

<font size="3" face="Arial">Marshall</font><br>

<font size="3" face="Arial">215-510-9400</font><br>

<font size="3" face="Arial"><a href="http://www.phillytuner.com" target="_blank">http://www.phillytuner.com</a> </font><br>
                                               </div>


</div>
 <!-- end of AOLMsgPart_1_5c1fd7b3-66b2-4773-80ad-d8838510d6b1 -->



</div>
</font>