I have seen such a thing which I&#39;m pretty certain was factory original. The third hole was tapped for a machine screw. IMO, a far less bad design than a wood screw into whateverness.<div><br></div><div>Paul Bruesch</div>
<div>Stillwater, MN<br><br><div class="gmail_quote">On Fri, Sep 7, 2012 at 10:23 AM, Susan Kline <span dir="ltr">&lt;<a href="mailto:skline@peak.org" target="_blank">skline@peak.org</a>&gt;</span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">
<u></u>


  

<div bgcolor="#ffffff" text="#000000">
<font size="-1"><font face="Courier New, Courier, monospace"><big><big>I
think what is &quot;best&quot; depends on how bad the break is and what situation
the piano is in. <br>
<br>
One decent repair of this inherently fragile system which I&#39;ve seen is
a strip of brass about two inches long, screwed into the back of the
music desk, which bends around the end. Three holes, two for the screws
into the back of the desk, and one which is just big enough for the end
screw to go through. I&#39;d put epoxy into the splits and let it set up
before installing the brass.<br>
<br>
If I remember right, I&#39;ve seen this setup factory original as well. <br>
<br>
If I&#39;m putting one of these music desks back on (without the brass
strip), I always warn the owner not to tighten the screws. Always leave
enough room for the music desk to move side to side a fraction of an
inch. Screws into end grain -- what a lousy idea.<br>
<br>
Susan Kline</big></big><br><br></font></font></div></blockquote></div></div>