<font color='navy' size='2' face='Comic Sans MS, sans-serif'>Check the block screw hole elevation on the belly rail cavity wall at both bass and treble locations. If they are the same then the elevation in both blocks will be the same. This will help locate the screw hole in the new block.&nbsp;<br>
<br>

<div style="clear:both"><font size="1" color="royalblue"><b><font face="Georgia, Times New Roman, Times, Serif"><font color="black"><font color="mediumblue" face="Comic Sans MS, sans-serif">Dale Erwin R.P.T.<br>
<font color="green">Erwin's Piano Restoration Inc.</font><br>
</font></font></font></b></font><font color="darkgreen"><span style="font-style: italic;"><b><font size="1"><font size="1" color="black"><font color="blueviolet"><font color="black"> <font color="black" face="Comic Sans MS, sans-serif">Mason &amp; Hamlin</font><font face="Comic Sans MS, sans-serif">/Steinway/</font><font color="black" face="Comic Sans MS, sans-serif">U.S. pianos</font><font face="Comic Sans MS, sans-serif"><br>
</font></font></font></font><font size="1" color="cornflowerblue" face="Comic Sans MS, sans-serif">www.Erwinspiano.com</font><font size="1"><br>
</font><font size="1" color="crimson" face="Comic Sans MS, sans-serif">Phone: 209-577-8397</font><br>
<font color="darkgreen"></font></font></b></span></font><tt><tt><font color="darkgreen"><br>
&nbsp;</font><br>
&nbsp; <font size="2"></font></tt></tt><br>
<br>
</div>
<br>
<br>

<div style="font-family:arial,helvetica;font-size:10pt;color:black">-----Original Message-----<br>
From: Ron Nossaman &lt;rnossaman@cox.net&gt;<br>
To: pianotech &lt;pianotech@ptg.org&gt;<br>
Sent: Fri, Sep 28, 2012 8:57 pm<br>
Subject: Re: [pianotech] Damper tray block<br>
<br>







<div id="AOLMsgPart_0_0bac0ceb-051e-47d6-9388-2fdabfc4c469" style="margin: 0px;font-family: Tahoma, Verdana, Arial, Sans-Serif;font-size: 12px;color: #000;background-color: #fff;">

<pre style="font-size: 9pt;"><tt>On 9/28/2012 8:37 PM, Ed Foote wrote:

&gt;   Hardest part is getting the hole right for the mounting screw. I would
&gt; place a punching, with just a spot of glue on one side directly over the
&gt; hole in the piano, and with more glue on the front, press the block on
&gt; to it so that the punching transfers to the back of the block. Drill there.

I believe I'd plug the hole and sidestep Murphy, to whatever degree 
that's possible. Though that might be the second try...
Ron N
</tt></pre>
</div>
 <!-- end of AOLMsgPart_0_0bac0ceb-051e-47d6-9388-2fdabfc4c469 -->



</div>
</font>