<HTML><HEAD></HEAD>
<BODY dir=ltr>
<DIV dir=ltr>
<DIV style="FONT-FAMILY: 'Calibri'; COLOR: #000000; FONT-SIZE: 12pt">
<DIV>Well Steve, you simply mount the TFT sensors between the front rail and the
balance rail on the action frame. The fingers should be preloaded to about
3 to 5 mm. This is accomplished by tipping the rail .........
adding shims (balance rail punchings) to get the desired preload (initial
movement or compression of the finger). Hooking the inter connecting
cables should be easy enough to figure out. They only go together one
way. Mount the connection interface on the hammer rail just above c88 or
as near as possible.</DIV>
<DIV> </DIV>
<DIV>The record board mounts on the inside of the rail cover. There’s
already holes to mount it to. The cables from above the keybed are
passed through the slot cut for the solenoid rail. There’s been some cases
where I’ve had to drill a hole big enough to pass the cable ends through the
belly rail .......... from memory, a seven eigths inch spoon
bit ........ maybe smaller. It’s late and I don’t remember when I
last did this.</DIV>
<DIV> </DIV>
<DIV>If you go on the OTHER forum and search for search terms record strip
or TFT you might find the images I posted there just for this purpose.</DIV>
<DIV> </DIV>
<DIV>Magic Star came out with a really nice product that does the same
thing. It was being marketed by PDS the last time I did one of these and
the instructions came with it. They were somewhat written to be seen and
read by experienced installers I think.</DIV></DIV></DIV></BODY></HTML>